Ventilation

Ridge & Hip Dry-Fix Ventilation System

 

  • Accepts most popular ridge profiles.
  • Eliminates wet trades.
  • Provides statutory airflow.
  • Ridge mechanically fixed.
Send us an enquiry about this product or give us a call for free:
01935 474769
Open Hours: Mon to Fri 8:00am - 5:00pm

Introduction

For location on prepared ridge and hip configurations.   Two-part system consisting of dry-fix roll-out ventilation membrane with corrugated flashings to both edges. Integral adhesive strips to underside of flashings initially hold in place prior to placement and securing of ridges over the membrane assembly using mechanically fixed flexible moulded retaining gaskets.

The flashing section of the membrane can be trimmed back should smaller ridges be deployed. Provides ventilation at high levels to satisfy statutory requirement. Also appropriate where supporting flow is required to aid ventilation via permeable underfelt to address NHBC directive.

Use

Promotes roof space ventilation at ridge and hip.

DATA

  • Rolls 6000mm x 325mm wide + retaining gaskets.
  • Max 5000mm² in continuous run to each side.
  • Black-Grey.
  • Alloy flashing, polymer gasket.
  • Compatible with most commonly available ridge and hip tiles.
You can buy our products at:

Products available from your local merchant, contact us to find out who is in your area

Contact us
All you need to know about Cavity Tray Standards